Herunterladen Inhalt Inhalt Diese Seite drucken

Adding Remote Controls - SOMFY CONTROL BOX 3S io Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für CONTROL BOX 3S io:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
Control Box 3S io
Operation with orange flashing light
The orange light is activated during any movement of the gate.
A 2-second pre-warning signal before movement starts may be programmed during installation.
Remote lighting operation
Depending on the programming performed during installation, the lighting comes on each time the motor is started and remains on when it stops for the
duration of the programmed time delay.
If a remote control is programmed for the remote lighting, operation is as follows:
With a 2- or 4-button remote control (Fig. 14)
Press the programmed button to operate the lighting.
Operation in sequential mode with automatic reclosing after time delay
The gate closes automatically after a time delay programmed during installation.
A new command issued during this time delay cancels automatic closing and the gate remains open.
The next command issued closes the gate.
Operation using the backup battery
If a backup battery is installed, the motorisation will work even during a power outage.
Operation is then activated under the following conditions:
• Reduced speed.
• The peripherals (photoelectric cells, orange light, wired code keypad, etc.) do not operate.
Battery specifications:
• Life: 24 hrs; 3 operating cycles depending on the weight of the gate.
• Recharging time: 48 hours
• Service life before replacement: Approximately 3 years.
For optimum battery life it is recommended that the main power supply be switched off and the motor operated using the battery for several cycles, three
times a year.

Adding remote controls

Keygo io (Fig. 16)
This operation is used to copy the function of a button on a memorised Keygo io remote control (remote control "A") to a button on a new Keygo io remote
control (remote control "B").
Remote control "A" = "source" remote control already memorised
Remote control "B" = "target" remote control to be memorised
For example, if the button on remote control "A" opens the gate fully, the button on the new remote control "B" will also open the gate fully.
Copyright © 2011 Somfy SAS. All rights reserved
14
2s
Remote control "A"
With a 3-button remote control (Fig. 15)
16
Remote control "B"
15
6

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis