Depending on the programming performed during installation, the lighting comes on each time the motorisation is started and remains on when it stops for

the duration of the programmed time delay.

If a remote control is programmed for the remote lighting, operation is as follows:

With a 2- or 4-button remote control (Fig. 14)

Press the programmed button to operate the lighting.

Operation in sequential mode with automatic reclosing after time delay

The gate closes automatically after a time delay programmed during installation.

A new command issued during this time delay cancels automatic closing and the gate remains open.

The next command issued closes the gate.

Operation using the backup battery

If a backup battery is installed, the motorisation will work even during a power outage.

Operation is then activated under the following conditions:

• With a 9.6 V battery:

• Reduced speed.

• The additional devices (photoelectric cells, orange light, wired code keypad, etc.) do not operate.

• With a 24 V battery:

• normal operation: speed normal, accessories functional.

• Life: 24 hrs; 3 operating cycles depending on the weight of the gate.

• Recharging time: 48 hours

• Service life before replacement: Approximately 3 years.

For optimum battery life it is recommended that the main power supply be switched off and the motor operated using the battery for several cycles, three

times a year.

Adding remote controls

Keygo io (Fig. 16)

This operation is used to copy the function of a button on a memorised Keygo io remote control (remote control "A") to a button on a new Keygo io remote

control (remote control "B").

Remote control "A" = "source" remote control already memorised

Remote control "B" = "target" remote control to be memorised

For example, if the button on remote control "A" opens the gate fully, the button on the new remote control "B" will also open the gate fully.

Remote control "A"

With a 3-button remote control (Fig. 15)

Remote control "B"

Inhaltsverzeichnis