Adding Remote Controls; Operating Diagnostics - SOMFY ROLLIXO RTS Bedienungsanleitung

Rollixo RTS

4.3 Adding remote controls

This operation must be carried out close to the receiver.
This operation involves adding a remote control to your installation by copying
a remote control already used on your installation.
Remote control "A" = "source" remote control already memorised
Remote control "B" = "target" remote control to be added
> 2 or 4-button remote control
A
A
[1]. Press the outer left and right buttons on the previously memorised remote
[2]. Press the remote control button A which controls your roller garage door
for two seconds.
[3]. Press the button on new remote control B which will control your roller
garage door.
> 3-button remote control
A
2s

5 - OPERATING DIAGNOSTICS

The indicator lights on the front of the Rollixo receiver notify the user of the
installation's status.
Safety edge
Motor
Fall protection
1
STOP
Indicator light status Meaning
Off Functional installation
Deactivation/activation in progress
Permanently lit Installation fault/failure
Indicator light status
Diagnostics Activated motor thermal protection
Motor
Consequences No movement possible
Actions Wait around 10 minutes.
4
All manuals and user guides at all-guides.com
B
2s
B
< 1s
Safety edge
transmitter batteries
Photoelectric
cells
2 3 4
Prog
Prog
Indicator light status
Radio interference on the safety edge
Diagnostics
transmitter
Opening and stopping ok
Consequences
Closing by pressing and holding down
the button within sight of the door
If a powerful radio system is present on
the site (infrared detector, TV transmitter,
etc.) and is transmitting on the same
Actions
frequency, the receiver will wait for the
transmission to end to before controlling
the door again.
Radio safety
edge
Safety edge transmitter low battery
Diagnostics
indication.
Opening ok
Consequences
Closing by pressing and holding down
the button within sight of the door
If the fault persists, replace the safety
Actions
edge transmitter batteries.
Diagnostics Obstacle detection
Remove the obstacle by automatic partial
Consequences
opening
Check that no obstacle is causing the
Actions
safety edge to detect.
Diagnostics Cell fault
Opening ok
Consequences
Closing by pressing and holding down
the button within sight of the door
Check that no obstacle is cutting across
Actions
Photoelectric
the cell beam
cells
Diagnostics Obstacle detection
Remove the obstacle by full automatic
Consequences
opening
Check that no obstacle is cutting across
Actions
the cell beam.
If a fault is still present on your installation, please contact your installer.
Prog
Copyright © 2014 Somfy SAS. All rights reserved.