Special Operation; Clearing Remote Controls And All Settings; Locking Programming - Fig - SOMFY DEXXO PRO RTS Installationsanleitung

EN
Special case: adjusting the position of the door for partial opening
- Pressing and holding the "-" button will close the door.
- Pressing and holding the "+" button will open the door.
OK
-
SET
-
Forced mode (Fig. 33)
- press the "-" button to close it
- press the "+" button to open it.
"-" or "+" button to stop the door.
Memorising the remote control for operation in «Partial opening»
mode (Fig. 34)
Memorising the remote control for controlling remote lighting
(Fig. 35)
Memorising a Telis or similar type remote control (Fig. 36)

8 - SPECIAL OPERATION

Refer to the user manual.
Adding a remote control without accessing the motor head (see
user guide Fig. 12a et 12b)
9 - CLEARING REMOTE CONTROLS AND
ALL SETTINGS
9.1 Clearing remote controls - Fig. 37
PROG
9.2 Resetting all settings - Fig. 38
SET

10 - LOCKING PROGRAMMING - FIG. 39

The keypad must be locked to ensure the safety of the end-users.
Non-observance of this instruction can result in serious injury to persons,
e.g. when trapped by a door.
SET "+", "-"
SET
-
- the "+" and "-" buttons must be pressed simultaneously within 2 seconds.
11 - REFITTING COVERS - FIG. 40
one of the two positions shown in Fig. 40.
OK
WARNING
12 - TROUBLESHOOTING
12.1 Operating codes displayed
Code Description
Door opening
Door closing
Obstacle detection
contact active
Permanent hardwired
control
battery
12.2 Programming codes displayed
Code Description Comments
Awaiting setting
learning mode.
Learning mode
cycle.
Awaiting Pressing a button on the remote control
remote control allocates this button to the motor total
opening control.
operation in total
opening
Awaiting Pressing a button on the remote control
remote control allocates this button to the motor partial
opening control.
operation in partial
opening
Awaiting remotely Pressing a button on the remote control
controlled lighting allocates this button to the remotely
memorisation controlled lighting control.
Dexxo Pro RTS
Comments
Displayed during obstacle detection
This display is maintained as long as
when the pedestrian door contact
is open.
The display is maintained as long
as the pedestrian door contact
remains open.
Indicates that the permanent
hardwired control input is activated
radio remote control units are
inhibited.
SET
OK
+ "-" buttons will control
PROG
F1
PROG
F2
PROG
F0