Keytis Remote Control Description; Keygo Remote Control Description; Fitting The Battery For Keytis Remote Controls - SOMFY Dexxo Pro io Installationsanleitung

Dexxo Pro io
[3]. Adjust the closed position using the "+" or "-" buttons.
Release the "-" button before the motor has time to force against
the door.
[4]. Press "OK
learning cycle.
The door runs through a complete Open Close cycle.
- If learning was correct, the display will show "C1
- If the learning cycle was not completed correctly, the display will show
"S1
- If the door is moving, pressing any button will stop the movement and interrupt
the learning mode.
- If the door is stopped, pressing "SET
You can call up the learning mode at any time, even when the learning cycle
has already been executed and the display shows "C1
At the end of installation, it must be checked that the obstacle detection
complies with annex A of the standard EN 12 453.

4.3 Keytis remote control description

1 - Individual control buttons
2 - General STOP button
3 - General CLOSE button (Keytis 4 home io only)
4 - Operation indicator light On
5 - Low battery indicator light
6 - Closing clip
7 - PROG
8 - KEY

4.4 Keygo remote control description

1 - Individual control buttons
2 - Operation indicator light On

4.5 Fitting the battery for Keytis remote controls

4.6 Programming Keytis remote controls - Fig. 18 to 22
with at least one programmed remote control
remote control, then go straight to Programming the
Keytis remote control step (Fig. 20 to 22).
7
WARNING
Intermittent Blinking
Intermittent Blinking
remote control by copying another Keytis remote control are only
remote control must be able to establish radio communication with
an installation receiver.
> Memorising the system key (Fig. 19).
[1].
- With a Keytis, Telis, Impresario, Composio
"KEY
-
[2]. KEY
> Programming the Keytis remote control (Fig. 20 to 22)
Before programming the remote control, make sure that it has already
memorised the system key.
Each control button is programmed individually.
A button that is already programmed cannot be programmed on a second
-
-
To clear a previously programmed button, refer to the section on Clearing
Keytis remote controls.
- Programming from a Dexxo Pro motor.
- Programming by copying a previously programmed Keytis remote
control.
> Programming from a Dexxo Pro motor (Fig. 20)
[1]. Press the "PROG
seconds).
[2]. PROG
Wait for the second beep and for the green indicator to start blinking
quickly.
This may take from a few seconds to around a minute depending on the
number of products connected to the system.
[3].
> Programming by copying a previously programmed Keytis
remote control
Completely copy the programming of a Keytis remote control (Fig. 21)
This operation is used to copy all of the buttons programmed from an already
programmed remote control.
[1]. Press the "PROG
until the green indicator comes on (two seconds).
[2]. PROG
Wait for the second beep and for the green indicator to start blinking
rapidly (a few seconds).
Individually copy the programming of a Keytis remote control button
(Fig. 22)
This operation is used to copy the programming of a single button from an
already programmed remote control.
[1]. Press the "PROG
until the green indicator comes on (two seconds).
[2].
control.
[3]. PROG
[4].
control.
Copyright © 2015 Somfy SAS. All rights reserved