Quick Commissioning; Memorising The Keygo Io Remote Controls For Operation In Complete Opening Mode; Self-Learning - SOMFY ELIXO 500 io Installationsanleitung

QUICK COMMISSIONING

Memorising the Keygo io remote controls for operation in complete opening mode

If this procedure is carried out using a channel which has already been
memorised, this channel will be cleared.
[1]. Press and hold the "PROG" button (2 s) on the programming interface.
The screen displays "F0".
[2]. Press the outer left and right buttons on the remote control together.
The remote control indicator light flashes.
[3]. Press the button of the remote control that will open the gate fully.
The screen displays "Add".

Self-learning

Self-learning allows the gate's speed, maximum torque and slowdown zones to be adjusted.
- Self-learning the gate's travel is an essential step in commissioning the motorisation.
- The gate must be in the intermediate position before self-learning starts.
- During self-learning,
and do not allow any persons near or inside the operating range of the motorisation.
- To carry out an emergency stop during self-learning, use a stored remote control or press one of the interface buttons.
Starting self-learning
[1]. Press and hold the "SET" button (2 s).
Release the button when the screen displays "H1".
[2]. Press "OK" to start self-learning.
Self-learning must start with the gate being opened.
The gate performs two complete Opening and Closing cycles.
[1]
2 s
2 s
H0 H1
• If self-learning starts when the gate is closed, stop the self-learning in progress
(press a control button: motor electronics, memorised remote control, wired
control point, etc.), move the slide as shown opposite, then restart self-learning.
• If self-learning is correct, the display indicates "C1".
• If self-learning has not completed correctly, the display indicates "H0".
At the end of installation, it is essential to check that the obstacle detection complies with appendix A of standard EN 12 453.
Copyright © 2012 Somfy SAS. All rights reserved.
the obstacle detection
[2]
[1] [2]
2 s
H0 F0
function is not active.
H2
H4
H2
H4
WARNING
Elixo 500 3S io
[3]
Add
Remove any objects or
C1
Self-learning correct
Self-learning incorrect
H0
H0
obstacles
9