Installation; Installation And Loading Of The Pump - Videotec WASNX Bedienungsanleitung

6 Installation

Before starting any operation, make sure
the power supply is disconnected.
6.1 Installation and loading of
the pump
We recommend filling the tank with water
at ambient temperature. If using the pump
at temperatures below 3°C (37.4°F) add
some glass cleaner antifreeze liquid to the
water.
During installation or maintenance operations of the
pump, you can leave the tank in place or remove it. To
remove the tank (01) loosen the metal clips (02) and
release the connection pipe (03) by exerting pressure
on the fast connection joint (04).
02
01
02
Fig. 11
Reduce any residual pressure in the tank using the
safety valve.
Fig. 12
8
03 04
Undo the top body of the pump (01) by turning it
anti-clockwise and removing it. Fill the tank (02).
01
02
Fig. 13
Screw in the upper casing of the pump.
Pressurise the tank pumping with the handle (01)
until the indicated pressure is reached (4bar). Turn
the handle to the safety position (02).
01
Fig. 14
Pass the delivery pipe (01) through the sealing ring
(02). Connect the delivery pipe to the solenoid valve
(fast connection joint).
01
02
Fig. 15
02
MNVCWASNX_1717_EN