Programming The Speed Controller; A) Programming Of Full Throttle And Neutral Positions; B) Programming The Special Functions - Reely ROAD Subaru Bedienungsanleitung


10.

Programming the Speed Controller

a) Programming of Full Throttle and Neutral Positions

For programming the full throttle positions for forward/reverse driving and the neutral position, proceed as follows:
• Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the trimming for driving into the
centre position.
• Keep the setup button pressed and turn the speed controller on. Press and hold the setup button until the orange
LED comes on (about 4 seconds). Then release the setup button.
• Move the throttle/brake lever into full throttle for forward driving (pull the throttle all the way towards the handle) and
keep it there.
The red LED flashes for about 2-3 seconds and then is lit permanently. The motor emits a sound signal. The full
throttle position for forward driving is stored.
The sound signal is generated because the brushless motor is activated for a moment. Depending on the
motor, this sound signal may be very low or inaudible. In this case, observe the LED on the speed control-
ler.
• Move the throttle/brake lever into full throttle for reverse driving (push the throttle away from the handle all the way)
and keep it there.
The orange LED flashes for about 2-3 seconds and then is lit permanently. The motor emits two sound signals. The
full throttle position for reverse driving is stored.
• Release the gas/brake so that it sits in the neutral position.
The red LED and the orange LED flash at the same time for about 2-3 seconds and go out then. The motor emits three
sound signals. The neutral position is now saved.
• Switch the speed controller off; the programming is complete and stored now.
• If you switch on the speed controller now, the speed controller is ready for operation with the settings made above.
If the throttle/brake lever at the transmitter is pulled towards the handle, the vehicle must move forwards.
If this is not the case, switch off the speed controller. Then activate the reverse setting for the driving
function at the transmitter. Then re-program the full throttle and neutral positions for the driving function;
proceed again as described above.

b) Programming the Special Functions

The speed controller is pre-programmed by the manufacturer with the settings best for the vehicle (e.g. motor timing,
start mode, etc.). This programming can be changed with a programming card available as an accessory.
The programming card is not part of the delivery. It must be ordered separately. All special functions and
their programming are described in the operating instructions for the programming card.
45