D) Switching On The Speed Controller; E) Attaching And Fastening The Car Body - Reely ROAD Carbon Fighter Bedienungsanleitung

d) Switching on the Speed Controller

If you didn't do so before, switch on the transmitter (see chapter 9. b).
Place the vehicle on an appropriate surface so that the wheels can turn freely.
Switch on the speed controller, put the slider on the bottom of
the chassis to the "ON" position (=switched on).
After a brief safety pause of approx. 5 seconds, the vehicle is
ready for operation.
If the motor does not stop, adjust the motor function trimming
on the transmitter (dial "TH.TRIM").
Now check the drive and steering functions of the vehicle.

e) Attaching and Fastening the Car Body

Now put the car body on the holders and fasten the vehicle panelling with the holding brackets removed at the start.
Your car is now ready for its first test run!
33