Programming The Drive Control - Reely ROAD Titan Bedienungsanleitung


11.

Programming the drive control

Normally, the drive control is already pre-programmed correctly. You can reprogram the vehicle in just a few steps, for
example if the drive starts although the throttle stick is in neutral position and the trim button cannot be adjusted to the
best extent.
Proceed as described below for reprogramming:
• Put the vehicle on a suitable support or starter box so that the wheels can turn freely and do not touch the ground.
• If you have not already done so, turn the remote control on, connect the accumulator pack with the drive control and
turn the vehicle on.
• Put trim control "TH.TRIM" (ill. 1, Pos. 8) in centre position. This might already cause the drive to move.
• Let go of the throttle on the remote control to return it to neutral position.
• Press the setup button on the drive control for approx. 2 seconds. The green LED of the drive control flashes.
The drive is turned off for safety reasons during programming!
• Shift the throttle on the remote control to full-throttle position for forward driving (pull the throttle towards the handle)
and then in the full-throttle position for reverse driving (push the throttle away from the handle). You may possibly do
this more than once. It is important that the throttle is moved to the respective final position.
Attention!
If you do not move the throttle on the remote control during the programming process or do not
move it far enough, the vehicle might respond to even slight movements of the throttle or become
uncontrollable. In that case, repeat programming.
• Now let go of the throttle on the remote control so that it returns to the neutral position (do not touch/shift).
• Briefly press the setup button on the drive control.
Now both LEDs (red and green) are lit to show you that the drive control is in the neutral position. The settings are
saved and the vehicle now responds to the remote control commands again.
The green LED is lit when driving forwards, the red LED when driving backwards. This is important if you
want to e.g. use a different remote control transmitter/receiver. Then set the reverse function on the
transmitter correctly.
If the vehicle still drives into the wrong direction (movement of the throttle on the transmitter into the right
direction, green LED is lit but the vehicle still drives backwards), exchange the two motor connection
cables to the drive control.
35