Setting The Shock Absorbers - Reely DT5 BL RtR Bedienungsanleitung

c) Setting the Shock Absorbers
C
Front axle
The spring-pre-tension at the upper end of the shock absorber can be adjusted by turning a knurled nut (A). Ensure
that the shock absorber body does not turn along and is turned from the shock absorber cap by this (oil loss threatens).
The shock absorbers at the vehicle's front and rear vehicle axles can be mounted in different positions lower transverse
link (C) and at the top of the the damper bridge (B). The manufacturer has, however, already chosen the best position;
therefore, only professional drivers should change these.
Always set the shock absorbers for one axle evenly (at the left and right wheels of the front or rear axle). Otherwise,
driving behaviour will be influenced negatively.
Optional accessories (not included in the delivery; can be ordered separately) that can be used include
springs with a different stiffness or damper oil of a different viscosity for filling the shock absorbers.
Just as with a "real" car, the shock absorbers (or the rubber seals in them) on the model car are a wearing part. If oil is
running from the shock absorbers (e.g. transverse link strongly oiled, dripping traces), the seals or shock absorbers
must be replaced.
B
A
B
A
C
Rear axle
45