Reely Dragontail Bedienungsanleitung Seite 53

"Battery Type": Set the battery type you are using with this function. If the setting is incorrect then the speed
controller or the rechargeable battery may be damaged (e.g. excessive discharging of a LiPo rechargeable battery).
This delivered vehicle and the including motor are exclusively suitable for use with NiMH recharge-
able batteries with 6 cells (nominal voltage 7.2V) or LiPo rechargeable batteries with 2 cells (nomi-
nal voltage 7.4V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed
controller. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differ-
ential). Loss of guarantee/warranty!
"Neutral Auto/Manual": In the "Auto" setting the current position at the remote control is taken as the neutral setting
when the speed controller is switched on.
In the "Manual" setting you can programme the speed controller's neutral and full acceleration setting for forwards
and reverse later when the speed controller is switched on for the first time.
See also chapter 10. a).
• Once the settings are complete press the "Enter" button, the settings made on the programming card are transferred
to the speed controller and saved, the motor emits 5 beeps.
• Switch off the speed controller ("OFF").
• Disconnect the driving battery from the speed controller.
• Remove the speed controller from the programming card.
• Connect the speed controller to the receiver again.
Ensure correct connection, since the speed controller will not work otherwise.
• Switch on your transmitter (check battery condition!). Put the trim controls in centre position. Put the gas/braking
lever in neutral position and let go of it.
• Switch off the speed controller ("OFF"), if you haven't done it yet already.
• Place the vehicle on an appropriate surface so that the drive can turn freely. Then insert the driving battery into the
vehicle and connect it to the speed controller.
• Switch on the speed controller ("ON"). The motor emits a variety of sounds.
 Automatic recognition of the neutral position is active (setting "Neutral Auto")
• The motor emits a confirmation sound "DO-RE-MI" to show that the speed controller is active.
• Then the motor emits a further confirmation sound ("DA-LA-DA-LA"), the current gas/brake lever setting is saved as
the neutral setting.
• The speed controller (and consequently the vehicle) is now ready for operation.
53