Reely Dragontail Bedienungsanleitung Seite 51

• Switch on the speed controller ("ON"). The motor/speed controller emits a variety of sounds.
 Automatic recognition of the neutral position is active (setting "Neutral Auto")
• The speed controller/motor emits a confirmation sound "DO-RE-MI" to show that the speed controller is active.
• Then the speed controller/motor emits a further confirmation sound ("DA-LA-DA-LA"), the current gas/brake lever
setting is saved as the neutral setting.
• The speed controller (and consequently the vehicle) is now ready for operation.
 Manual recognition of the neutral position is active (setting "Manual")
• The motor/speed controller emits 3 beeps.
The following programming must be carried out within 15 seconds, as the speed controller will otherwise
return to the automatic recognition mode for safety reasons.
To programme the speed controller again the programming card must be reconnected and the "Manual"
setting must be selected under "Neutral auto/manual" and must be confirmed with the "Enter" button. Only
then can a new manual setting of the neutral and full throttle setting be carried out, as described in the
following.
• Now move the throttle/brake in the "full throttle forwards" position and keep it there for 2 seconds. The motor emits
3 beeps.
• Now move the throttle/brake lever to the "full throttle backwards" position and keep it there again for two seconds.
The motor emits a sound signal ("DO-RE-MI").
• At the end, move the throttle/brake lever to the neutral position and release it. After 2 seconds the motor emits a
sound signal ("DA-LA-DA-LA"), the gas/brake lever settings for forward/reverse full acceleration is saved as is the
neutral setting.
• The speed controller (and consequently the vehicle) is now ready for operation.
51