Safety Instructions; A) General; Before Operation - Reely SKY Space Runner Bedienungsanleitung

Assembly:
Soldering gun, box cutter, screwdriver, Allen key, glue for polystyrene foam, superglue for polystyrene foam, 5-minute epoxy glue, if needed thixotropic agent
(micro balloons or cotton flocks) to thicken the glue, heat-shrink tubing, Velcro fastener and servo tape.
Caution!
Observe the safety notes of the respective manufacturer when using glues and work with glues in well-ventilated rooms only.
Important!
Only use superglue suited for rigid foam! Common superglue may dissolve the foam and damage it.
Operation:
To fly the model, a suitable remote control with at least 4 channels and a delta mixer, two mini servos with suitable extension cables, a suitable speed controller
and a suitable flight battery with corresponding connectors are required.


6. Safety instructions

The guarantee/warranty will be void if damage is incurred resulting from non-compliance with the operating instructions. We assume no
liability for any consequential damage!
Nor do we assume liability for damage to property or personal injury caused by improper use or the failure to observe the safety
instructions! In such cases the warranty/guarantee is voided.
Normal wear and tear and accident and crash damages (e.g. broken propeller or other broken parts) are also excluded from the guarantee and
warranty.
Dear Customer,
These safety instructions are not only for the protection of the product but also for your own safety and the safety of others. This is why you should
read this section very carefully before using the product!

a) General

Caution, important note!
Operating the model can lead to material and/or personal damage. Therefore, make sure that you are properly insured when using the model, e.g.
by taking out private liability insurance. If you already have insurance, enquire whether the operation of the model is covered before operating it.
Please note: In some EU countries, you are required to have insurance for any flying models!
• For safety reasons, any unauthorized conversion and/or modifications to the product or its components are not permitted.
• The product is not a toy. It is not suitable for children under 14 years of age.
• The product must not become damp or wet.
• If you do not have sufficient knowledge as to how to deal with remote-controlled models, please seek the advice of an experienced model maker or a model
making club.
• Do not leave packaging material lying around unattended. It can become a dangerous toy for children.
• Should any questions arise that are not answered in the operating instructions, contact our technical support (see chapter 1 for contact information) or another
expert.
b) Before operation
• Unroll the aerial wire of the receiver in the model to its complete length. Parts protruding from the model must not be bent toward the front, attached to the
model or cut off. Reception is optimal when the aerial wire loosely protrudes from the model and is dragged along in flight.
• Make sure that no other models are operated on the same channel (transmitter frequency) within the range of the remote control. Otherwise, you will lose
control of the remote-controlled models! Always use different channels if you wish to operate two or several models in the immediate proximity of each other
simultaneously.
• Regularly check the functional reliability of your model and the remote control system. Watch out for visible damage such as defective plug connections or
damaged cables. All moving parts of the model must run smoothly, but should not have any play in their bearings.
• Charge the flight battery necessary for operation as well as rechargeable batteries in the remote control according to the instructions provided by the
respective manufacturer.
16