Gastroback DESIGN MULTI JUICER DIGITAL Bedienungsanleitung Seite 89

used processing system is not closed correctly. Do not attempt to inactivate the
safety interlocks.
CAUTION:
off the appliance before checking, which safety interlock of the appliance is not
closed correctly. When in operational mode (display is illuminated), the motor will
start agitating IMMEDIATELY as soon as the affected safety interlocks are enga-
ged.
Self-Resetting Overheat Protection Device
If overheating occurs, the appliance will automatically stop operation at once, which
safeguards against overheating of the motor and ensures an elongated working life
of the motor. If the overheat protection device is triggered, switch off the appliance
completely (turn the selection dial to "OFF" and switch off at the rear power switch),
remove the power plug from the mains power supply and leave the motor cool down
by waiting approx. 30 minutes. Overheating may be caused by ...
• too much food in the processing system. Always observe the MAX filling levels
of the various processing systems as given in chapter 'Technical Specifications'.
When juicing, do not push down your food with too much pressure. Take out
some food and try again.
• too hard ingredients or too much fibres obstructing the processing system. Maybe
another processing system/blade assembly is required. Please observe the recom-
mends given in section 'Selecting the Optimum Processing System'.
• the appliance has been operated continuously for an elongated time. Especial-
ly with the optional accessories, the appliance will process your food within
seconds. It is better to avoid over-processing. However, if an elongated proces-
sing time is really required, you need to make sufficient brakes.
• hard ingredients or too much fibres are gridlocked within the knives and block the
drive. Remove the used processing system from the motor base and remove the
obstacle (see: 'Operation' and 'Care and Cleaning'). Perhaps, you need to use
another processing system for processing your food (see: 'Selecting the Optimum
Processing System').
Tip: You may use the required time for cooling down (approx. 30 minutes) to
remove any obstacles and blockages in the used processing system and preparing
another portion of your food. After solving the problem and leaving the motor cool
down, you can reactivate the appliance quite as normal.
Important: For performing the reset, the appliance MUST be unplugged from the
power outlet.
If the motor does not start when selecting a speed, always switch
89