Gastroback DESIGN MULTI JUICER DIGITAL Bedienungsanleitung Seite 108

system to and fro until it settles down easily on the drive rotor and achieves a
stable stand on the motor base.
CAUTION:
motor base, do not grasp the glass jug. Always grasp the collar of the blade
assembly to avoid damage to the thread connecting the glass jug and blade
assembly. Additionally, the connection could get over-tightened, making it extre-
mely difficulty to remove the blade assembly after operation.
7. Grasp the blade assembly with both hands by the collar and turn it clockwise
for fixing it to the motor base (turn it a little more than a finger's breadth after
feeling the first resistance). The appliance is now ready for operation.
CAUTION:
ly, when connecting the appliance to the power supply, with the power switch and
selection dial in operating position. Thus, always switch the power switch to "O"
and selection dial to "OFF", before plugging in the power plug.
8. Ensure that the selection dial and power switch are turned to the "OFF" position.
Then insert the power plug into an appropriate wall power outlet (see: 'Important
Safeguards for Electrical Appliances').
CAUTION:
wise, due to the high power of the motor, liquids and food will be hurled out vio-
lently, and liquids will run down at the exterior of the glass jug. With hard ingre-
dients in the glass jug, always keep a hand on the lid.
Note
If the rotating speed slows down visibly during operation or the motor stalls, there
may be too much food in the glass jug, and/or there are too many too hard ingre-
dients blocking the knives (see: 'Electronic Overload Protection'). Switch off the
appliance at the selection dial and power switch and unplug. Remove any obsta-
cles. If required, take out some food and process your food in smaller portions.
Tip: The appliance will process your food in seconds. It is better to intermediately
check the consistency of your food (after processing a few seconds) than to over-
process your food.
9. Switch the power switch at the rear of the motor base to the ON position ("I").
Then, keeping one hand on the lid of the glass jug, turn the selection dial to
the desired speed level (see: 'Tips for Best Results'). The motor starts agitating at
once. If not, in most cases, the threads of the processing system are not assem-
108
For mounting or dismounting the mixing/mincing system at the
Please keep in mind that the motor will start operation immediate-
Do not remove the lid of the glass jug during operation! Other-