Gastroback DESIGN MULTI JUICER DIGITAL Bedienungsanleitung Seite 113

Note
If the motor does not start, when selecting a speed level, check whether the con-
nections of the blade assembly to the grinding cup and the motor base are suffi-
ciently tight. Always switch off the appliance, before checking the connections.
10. Switch the power switch at the rear of the motor base to the ON position
("I"). Then, turn the selection dial to the desired speed level (see: 'Tips for Best
Results'). The motor should start agitating at once. If not, see: 'Solving Problems'.
11. After grinding is done, turn the selection dial to the "OFF" position, switch off
the appliance at the power switch, and unplug. Then disassemble the appliance
(see: 'Disassembling the Appliance after Grinding') for getting out your food.
Important: Do not leave the appliance unattended when it is connected to the
power supply.
Disassembling the Grinding System
12. Ensure that the selection dial is turned to "OFF" and the power switch is switched
off ("O"). Unplug the appliance.
CAUTION:
grasp the blade assembly. Otherwise, the connection of the grinding cup and
blade assembly cold get loose and your food will fall out.
Do not strike the grinding cup against any hard or sharp-edged object for loo-
sening the food from the blade assembly. However, you may hit the grinding cup
slightly against your palm.
13. Grasp the blade assembly by the collar and turn it counter-clockwise to unscrew
it from the motor base. Then lift the grinding system from the motor base.
14. Hold the grinding system with the blade assembly facing upwards and hit the
grinding cup slightly with your palm or shake the powder from the blade assem-
bly into the grinding cup.
Tip: For keeping your workspace clean, we recommend to open the grinding sys-
tem over a large dish.
15. Turn the blade assembly counter-clockwise for removing the blade assembly.
16. Remove your food. If you do not wish to process another portion, clean the used
parts (see: 'Care and Cleaning').
Do not turn the processing system by the grinding cup. Always
113