Connection - Conrad 85 66 75 Bedienungsanleitung

Connection

After installation of all components, you have to connect the display cables and the voltage supply.
The following sketch shows the wiring of all components.
12V/DC
FUSE
BOX
Connect all cables as depicted in the connection scheme.
• Connect the 6-pole plug on the monitor connection (11) with the black socket of the monitor connec-
tion cable (10).
• Plug the small white plug of the DISP connection cable (4) into the socket "DISP" of the control unit
(1). The plug only fits in the socket with the correct polarity. The "DISP" connection line includes two
cable pairs with the words "Video" and "NTSC". Each cable pair consists of a signal line (yellow cinch
connector) and a power line (black barrel connector).
• Connect the yellow "Video" cinch connector with the yellow "VIDEO2 IN" cinch socket of the monitor
connection cable (10).
• Connect the black barrel plug on the "Video" cable pair with the black socket (Reverse +) of the mon-
itor connection cable (10). This plug is used to supply the mirror screen with power during reverse dri-
ving. It then switches to camera mode.
Reverse +
VIDEO2 IN
Video
DVD/VIDEO
VIDEO1 IN
PWR DISP ALM
R
NTSC
A B C D
D
C
B
A
Camera
29