Herunterladen Inhalt Inhalt Diese Seite drucken

Conrad 85 66 75 Bedienungsanleitung Seite 29

Rückfahrvideosystem mit 7er-tft im rückspiegel und einparksensoren
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Installing lines and components
Guide the connection cables of the ultrasound sensors from the outside
through the bumper to the trunk opening. Carefully place the cables inside so
that no moisture penetrates the inside of the car.
Attach the control unit (1) with the enclosed adhesive pad. A suitable place is
the side wall in the watertight trunk close to a taillight. Make sure that the con-
nection lines of the sensors reach up to the control unit (1).
Install the connection cables of the sensors in line with the connection diagram
in the chapter "Connection".
Attach the warning buzzer (3) with the included adhesive tape as well. For this
purpose, pull the protective paper off the pad.
The surface to which it is attached must be absolutely clean and grease-free. Do not attach
the pad below 5 °C, otherwise the pad will not stick properly.
When installing the cables in the sides of the car etc., make sure that you do not damage
any safety-relevant equipment (e.g. side airbags)
Assembly of the rear-view mirror
The most important piece of the reverse driving video system is the rear-view mirror with integrated TFT
monitor.
Pull the clamp of the rear-view mirror on the rear apart and place it on the vehicle's rear-view mirror.
Install the connection cables in the fold of the car roof.
When selecting the installation site, make sure that the display is not in the direct visibility
range of the driver or in safety-relevant areas (airbags, etc.).
28

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis