Herunterladen Inhalt Inhalt Diese Seite drucken

Inserting And Changing The Battery In The Remote Control - Conrad 85 66 75 Bedienungsanleitung

Rückfahrvideosystem mit 7er-tft im rückspiegel und einparksensoren
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Inserting and changing the battery in the remote control

Before you can work with the remote control, you need to insert the included lithium battery.
Proceed as follows to insert or change the batteries:
Turn the remote control around.
Press the plastic latch towards the centre of the case and pull
the battery holder out of the remote control.
Insert a new lithium button cell type CR2025 into the holder
observing the right polarity. The plus pole of the battery points
upwards.
Slide the battery holder back into the casing until it snaps into place.
Do not leave flat batteries in the device. Even batteries protected against leaking can cor-
rode and thus release chemicals which may be detrimental to your health or destroy the
device.
Remove the batteries if the device is not used for longer periods of time to prevent leaking.
Leaking or damaged batteries may cause alkali burns if they come in contact with the skin.
Therefore, use suitable protective gloves.
Make sure that the batteries are not short-circuited. Do not throw batteries into the fire.
Batteries must not be recharged. Danger of explosion!
Do not leave batteries lying around. They could be swallowed by children or pets. If swal-
lowed, consult a doctor immediately.
Order a matching replacement battery (order no. 65 01 20, order 1 time).
33

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis