Preparation; Installation - Conrad 85 66 75 Bedienungsanleitung

Preparation

With the application of four ultrasound
sensors, the reverse drive space is
almost completely monitored. The sen-
sors must be installed evenly across the
width of the vehicle.
The illustration shows the sensor range
in two perspectives.

Installation

In order to install the sensors, you need a drill in order to drill the necessary holes into the bumper.
Prior to drilling, carefully mark the position of the holes.
Make sure that the sensor angle is not
obstructed by vehicle parts. This would
lead to malfunctioning.
The ultrasound sensors must be installed
evenly across the width of the vehicle.
The distance between the sensors may
not exceed 30 to 40 cm.
The installation height should be in a
range from 50 to 80 cm.
Mount the camera in the centre to enable
the best angle of view.
26