Troubleshooting - Conrad WH1070 Bedienungsanleitung

wherever batteries/accumulators are sold!
You thus fulfil the legal requirements and make your contribution to the
protection of the environment!

19. Troubleshooting

By purchasing this system you have acquired a product that has been designed to
the state of the art and is operationally reliable.
Problems and malfunctions may, however, still arise.
We would therefore like to describe how you can eliminate certain malfunctions your-
self.
Problem
Base station cannot Disturbances in reception See the chapter „Range and
always receive
the outdoor sensors
The base station
shows strange
characters or not all
segments of the
display
The contrast
of the display is
weak
The data of the
outdoor sensors
cannot be
received.
The display of
base station shows
„- -" or „- - -"
The base station
shows wrong
values
Always follow the safety instructions carefully.
Possible cause
Batteries are flat
Radio range
The device is
„quit"
Batteries are weak
Disturbances in reception See the chapter „Range and
of the outdoor sensor data Reception problems"
The batteries in the
Temperature/air humidity
sensor are spent
Batteries are flat
Error remedy
Reception problems"
and „Outdoor sensor"
Replace the batteries!
Change the location of the base
station or the outdoor sensors
Remove the batteries from the
base station and wait approx.
10 Minutes. Then proceed as
described in the chapter
„Battery Replacement".
Change the batteries in the
base station. Then proceed as
described in the chapter
„Battery Replacement" .
Change the batteries in the
Temperature/air humidity sensor.
Then proceed as described
in the chapter „Battery Replacement".
Check and exchange the
the batteries of the
base station or the temperature/
air humidity sensor. If the
77