Conrad WH1070 Bedienungsanleitung Seite 72

3. With the SET button, you can call up the individual alarm values in sequence to
set them.
4. With the +/
(blinking). If you keep the +/
can speed up the setting (quick set).
5. After setting an alarm value, you have to activate the corresponding alarm, other-
wise it will not function. You activate the alarm function for the respective alarm
value by pressing the ALARM button (small loudspeaker symbol appears).
6. To deactivate the alarm function, press the ALARM button again while the respec-
tive alarm value is called up (loudspeaker symbol goes off). The alarm function is
switched off.
7. Press the SET button to call up the next alarm value for setting.
8. You can skip individual settings by briefly pressing SET repeatedly. At the end of
the setting sequence, the device leaves the setting mode and returns to normal
display mode.
You can leave the setting function immediately by pressing the HISTORY
button. If no button is pressed for approx. 10 seconds, the device auto-
matically leaves the setup function.
Call up the alarm setting function and set the desired alarm functions in sequence.
Setting sequence for the top alarm value („HI AL")
1. Wake-up alarm (hour / minute)
2. Top alarm value for indoor air humidity.
3. Top alarm value for indoor temperature.
4. Top alarm value for outdoor air humidity.
5. Top alarm value for outdoor temperature.
6. Top alarm value for windchill temperature.
7. Top alarm value for dew point
8. Top alarm value for air pressure
9. Top alarm value for wind speed
10. Top alarm value for wind gust speed
11. Top alarm value for the rain quantity in 1 hour („1h")
12. Top alarm value for the rain quantity in 24 hours („24h")
If you press the SET button after setting the last top alarm value (rain quantity in 24
hours), the device returns to normal display mode.
72
- button or MIN/MAX button, you change the respective value
- button or the MIN/MAX button depressed, you