Fitting And Cleaning The Cutter (Accessory); Fitting The Cutter - Phoenix Contact UM IA THERMOMARK X1.2 Handbuch

5

Fitting and cleaning the cutter (accessory)

Fitting the cutter

103938_ia_01
5.1 Fitting the cutter
There are two types of cutters available as accessories:
– A cutter for labels (THERMOMARK X1-CUTTER, Order No. 5145290)
– A perforator and cutter for marker sleeves (THERMOMARK W2-CUTTER/P,
Order No. 5146244)
Both cutters are fitted in the same way.
Notes on the cutter
WARNUNG:
The cutter may only be fitted and removed when the printer is switched off.
The blades of the cutter are sharp. Risk of injury, especially when carrying out
maintenance work.
Only operate the cutter when it is mounted on the printer.
Do not cut any media that is wider or thicker than indicated in the specification.
Do not reach into the area of the moving blades during operation.
Mounting the cutter
1
2
Figure 5-1 Mounting the cutter
• Switch off the THERMOMARK X1.2.
• Insert the cutter (1) with the pins in the catch holes of the printer.
• Press the cutter against the printer. When you do this, the connector attached to the
cutter makes contact with the I/O connection of the printer.
Fitting and cleaning the cutter (accessory)
PHOENIX CONTACT
5-1