Connecting To A Computer Via Usb; Ethernet Interface - Phoenix Contact UM IA THERMOMARK X1.2 Handbuch

CLIP PROJECT advanced
103938_ia_01
2.3.2

Connecting to a computer via USB

ACHTUNG: Errors during operation due to insufficient or missing grounding
Make sure that all computers and connecting cables connected to the
THERMOMARK X1.2 are grounded.
A printer driver must be installed if a USB interface is to be used for connection. You will find
the appropriate printer driver for your device on the CD-ROM that was supplied with the
printer or on the Internet at www.phoenixcontact.net/catalog.
• Switch on the computer.
• Exit all programs that are currently running.
• Switch on the THERMOMARK X1.2.
• Connect the computer and THERMOMARK X1.2 using the USB cable supplied.
• Insert the CD-ROM with driver software into the CD-ROM drive.
• The Windows Installation wizard is started automatically.
• Follow the on-screen instructions.
• If the "Has not passed Windows logo testing" error message appears during
installation, continue with the installation anyway.
Following successful installation, an icon for the THERMOMARK X1.2 appears in the
Windows "Printer" system folder.
Next, set up the THERMOMARK X1.2 in the CLIP PROJECT advanced planning and
marking software.
• Select the THERMOMARK X1.2 printer in CLIP PROJECT advanced under
"File... Printer setup...".
2.3.3

Ethernet interface

See "Configuring the Ethernet interface" on page 3-5.
Connection and printing
2-3
PHOENIX CONTACT