Configuring The Ethernet Interface - Phoenix Contact UM IA THERMOMARK X1.2 Handbuch

103938_ia_01
3.5

Configuring the Ethernet interface

ACHTUNG: The offline menu contains several levels of setting options. The Ethernet
interface can be configured under Settings > Interfaces.
All other settings are set to optimum settings and must not be modified.
The integrated Ethernet interface allows operation of the printer in a network. Interface
settings are made on the printer.
The following parameters are necessary for operation of the printer in a network. If
necessary contact your network administrator.
– IP address
– Subnet mask
– or gateway
Alternatively, the Ethernet configuration can be obtained via a DHCP server. Make sure that
the same configuration is always transferred.
Setting the Ethernet interface on the printer
• Press the menu button.
button until you access the Settings
• Press the
• Press to confirm your selection.
button until you access the Interfaces
• Press the
• Press to confirm your selection.
button until you reach the Ethernet
• Press the
Confirm the selection by pressing
• Select the desired setting with the
Press ↵ to confirm your selection.
•
• Use the button to return to the higher menu level.
• At the top menu level, press
Ready state.
Description of the operating elements
item.
item.
item.
.
and keys.
several times to switch from the offline menu to the
3-5
PHOENIX CONTACT