Loading Media - Phoenix Contact UM IA THERMOMARK X1.2 Handbuch

THERMOMARK X1.2
Inserting roll material
2-6
PHOENIX CONTACT
2.4.3

Loading media

Positioning labels or continuous media on the media hub
Figure 2-3 Inserting roll material
• Open the cover.
• Remove margin stop. To do this, turn the adjustable ring (5) counter clockwise so that
the arrow (6) points to the
• Remove margin stop (4) from the media hub (3).
• Push material roll (2) onto the media hub so that the side to be printed is facing
upwards.
• Place the margin stop (4) onto the media hub (3) and push until both margin stops
(1, 4) are adjacent on the material roll and further pushing is resisted.
• Clip marginal stops to the media hub. To do this, turn the adjustable ring (5) clockwise
so that the arrow (6) points to the
1
2
3
4
5
symbol.
symbol.
4
6
5
3
103938_ia_01