Connection And Printing; Unpacking The Thermomark X1.2; Setting Up The Thermomark X1.2 - Phoenix Contact UM IA THERMOMARK X1.2 Handbuch

2

Connection and printing

Removing the
transportation safeguards
103938_ia_01
2.1

Unpacking the THERMOMARK X1.2

• Lift the THERMOMARK X1.2 out of the box.
• Check the THERMOMARK X1.2 for damage which may have occurred during
transport.
• Check delivery for completeness.
Scope of supply
– THERMOMARK X1.2-PRINTER thermal transfer printer
– Mains cable (Europe and US)
– USB cable
– empty cardboard core (if necessary, ready-mounted on the ink ribbon take-up hub)
– CD-ROM with this manual and drivers
– CD-ROM with marking software
Retain the original packaging for subsequent transport.
2.2

Setting up the THERMOMARK X1.2

Select installation location
ACHTUNG: The device and the print media can be damaged by humidity and
water.
The THERMOMARK X1.2 may only be set up in a dry location protected from spray.
The following are not suitable:
– Damp or dusty locations
– Environments that are subject to increased heat, direct sunlight or low temperatures
(operating range: 10 °C to 35 °C).
Place the THERMOMARK X1.2 on a level, stable surface. The room must be dry, free of
frost, and well-ventilated.
Removing the transportation safeguards
• Set up the THERMOMARK X1.2 on a level surface.
• Open the cover of the THERMOMARK X1.2.
• Remove the foam transportation safeguards near the print heads.
Connection and printing
2-1
PHOENIX CONTACT