Renaming Computers; Enabling Or Resetting Ps/2 Mouses - Guntermann & Drunck DVIMUX8-OSD-PS/2 Installationsanleitung

Renaming computers

NOTE: Only the Supervisor and users with configuration rights (see page 26) can
rename a computer.
In the defaults, the different computers are automatically named. The name com-
prises the term , a space and the number of the computer (for example
CPU
The names can be edited and may contain up to 14 alphanumeric characters.
How to rename computers in the KVM switch:
1. Press Ctrl+Num (Standard) to open the On-Screen Display.
2. Press to open the menu.
F1
3. Use the
Arrow keys
4. Choose the computer you want to rename.
5. Enter the name and press
NOTE:
You can also press
by pressing .
Enter
6. Repeat steps 4 and 5 to rename another computer.
7. Press F1 to save your settings.

Enabling or resetting PS/2 mouses

Unlike USB mouses, PS/2 mouses do not support hot plug technology. You can
therefore insert the PS/2 plug during operation, but the input device might not be
detected by the computer.
To enable or reset the PS/2 mouse, the KVM switch can be used to send a special
command to the computer.
Since the commands differ depending on the used mouse type and the installed
operating system, four different setup keys are provided.
to choose and press
CPU Config
CPU CONFIG
Channel
1
2
...
8
Esc Enter
Enter .
Enter and edit the current name. Confirm your entry
Getting started
.
Enter
DVIMUX8
Name
CPU 1
CPU 2
CPU 8
F1:Save
G&D DVIMUX8-OSD-PS/2 · 16
).
CPU 4