Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Increasing the number of connectable computers
Monitor:
Insert the 15-pin D-Sub plug of the computer connection cable (CPU) that is
connected to the master switch.
NOTE:
To connect the computer to the slave switch, follow the instructions on
page 4.
Changing the mode of »CPU« interfaces
In the default configuration, the KVM switch is configured to connect computers to
the
CPU
interfaces.
When connecting a slave switch to one of the
interface accordingly. Now the master switch can access the computers that are con-
nected to the slave switch.
How to change the mode of CPU interfaces:
1. Press
Ctrl+Num
2. Press
F1
to open the menu.
3. Use the
Arrow keys
4. Use the
Arrow keys
5. Select the interface whose mode you want to change. Press
the following options:
CPU:
miniMUX4:
miniMUX8; DVIMUX8-OSD:
6. Repeat step 5 to change the mode of another interface.
7. Press
to save your settings.
F1
NOTE:
The On-Screen Display of the slave switch is disabled. You can operate the
switch by using the On-Screen Display of the master switch.
49 · G&D DVIMUX8-OSD-PS/2
(standard) to open the On-Screen Display.
to select
System Config
to select
Cascade Setup
Connection of a computer
Connection of the miniMUX4 KVM switch
Connection of the miniMUX8 or
the DVIMUX8-OSD KVM switch
CPU
interfaces, change the mode of the
and press
Enter
.
and press
Enter
.
Space
to select one of
Werbung
Kapitel
Inhaltsverzeichnis
