Entering The Time - Sentiotec CK 31 Montage- Und Gebrauchsanweisung

Instructions for use for the user

8.5. Entering the time

The sauna control unit is completely disconnected from the mains using the op-
eration switch
1
battery. After putting the sauna control unit into operation for the first time, the
current time must be set.
1. Switching on the sauna control unit
Press ON/OFF switch
● The indicator lights
● The TIME
g
● The indicator light of the last selected bath type SAUNA
goes on.
2. Setting the current time [0 - 24]
The TIME menu item must be activated: The indicator light
a) Press the PROG/OK
● In the display
6
● The display
6
this time, otherwise setting mode will terminate and it must be selected again.
b) Using the UP/DOWN buttons
c) Press the PROG/OK
The display stops flashing. The time has been set.
6
WORLD OF WELLNESS
. The saved settings and the time are retained by an internal
:
1
- go on for approximately 5 seconds.
c f
indicator goes on. (e.g. 12:00): 12:00
button:
9
flashes: 12:00 or the previously set time.
flashes for 20 seconds, and the setting must be started within
8
button:
9
, set the desired value, e.g. [18:00].
p. 23/44
or CLIMA
h a
goes on.
e
EN