Connecting The Evaporator; Connecting The Light; Connecting The Fan (Optional); Connecting The Optional Power Enhancement - Sentiotec CK 31 Montage- Und Gebrauchsanweisung

Instructions for installation and use

5.2. Connecting the evaporator

● Guide the evaporator lines through the installation opening
area for 230 V / 400 V
cording to the circuit diagram (Fig. 7) to the terminal
tightening torque of 1.2 Nm.

5.3. Connecting the light

● Guide the light lines through the installation opening
230 V / 400 V
i
circuit diagram (Fig. 7) to the terminal

5.4. Connecting the fan (optional)

● Guide the fan lines through the installation openings
230 V / 400 V
i
the circuit diagram (Fig. 7) to the terminal

5.5. Connecting the optional power enhancement

● Guide the line for the connection to terminals ST1, ST2, ST3 of the power
enhancement through installation opening
400 V ) into the housing lower part
i
stallation instructions of the power enhancement.

5.6. Connecting heater sensor F1

1. Guide the wires for the heater sensor through the cable bushing
low-voltage connection area
2. Connect the red wires for the heater sensor to the terminals labelled "r-r"
in terminal strip
3. Connect the white wires for the heater sensor to the terminals labelled
"w-w" in terminal strip
WORLD OF WELLNESS
) into the housing lower part
i
) into the housing lower part
) into the housing lower part
.
4
.
3
.
3
1
j
(connection area for
h
and connect according to the
1
(as described in subsections in 3).
k
(connection area for
h
and connect according to
1
.
k
(connection area for 230 V /
g
and connect according to the in-
1
p. 15/44
(connection
9
and connect ac-
with a maximum
into the
8
EN