Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8 . Operations Instruction
Relevant operations of this software.
8.1. How to Set the Probe Attenuation Coefficient
The probe has several attenuation coefficients, which will influence the vertical scale factor of the
oscilloscope.
To change or check the probe attenuation coefficient in the menu of oscilloscope:
(1)
Click
to show Function menu, choose "Channel".
(2)
Set "Probe Rate" to the proper value corresponding to the probe.
This setting will be valid all the time before it is changed again.
Caution:
The default attenuation coefficient of the probe in the software is preset to10X. Make sure that the set
value of the attenuation switch in the probe is the same as the menu selection of the probe attenuation
coefficient in the software.
The set values of the probe switch are 1X and 10X.
Caution:
When the attenuation switch is set to 1X, the probe will limit the bandwidth of the oscilloscope in
5 MHz. To use the full bandwidth of the oscilloscope, the switch must be set to 10X.
8.2. How to Set the Vertical System
You can set the corresponding parameters of vertical system in the Channel window (18/19 in
Interface).
Figure: Attenuation Switch
-78-
7.User
Werbung
