PeakTech 1280 Bedienungsanleitung Seite 109

22. Technical Specifications
Unless otherwise specified, the technical specifications applied are for this oscilloscope only, and
Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two conditions at first,
these specification standards can be reached.
This instrument should run for at least 30 minutes continuously under the specified operating
temperature.
If change of the operating temperature is up to or exceeds 5°C, do the "SelfCal" procedure in Utility
menu (see Self Cal).
Performance Characteristics
Bandbreite
Channel
Acquisition
Input
Mode
Sample rate
(real time)
Input coupling
Input impedance
Probe attenuation factor
Max. input voltage
Channel –
channel isolation
Time delay between
channel (typical)
Instruction
P 1280
P 1285
P 1290
P 1325
P 1330
P 1280 / 1285 / 1290
P 1325 / 1330
Normal, Peak detect, Averaging
P 1280
P 1285
P 1290
P 1325
P 1330
DC, AC, Ground
1 MΩ ± 2% in parallel with 10 pF ± 5 pF
1X, 10X, 100X, 1000X
P 1280 , P 1285,
P 1325, P 1330
P 1290
50 Hz: 100 : 1
10 MHz : 40 : 1
150 ps
-109-
60 MHz
100 MHz
25 MHz
60 MHz
100 MHz
2 + 1 (* External)
4 + 1 (* Extern)
Dual CH 250 MSa/s
Single CH 500 MSa/s
Dual CH 500 MSa/s
Single CH 1 GSa/s
Dual CH 100 MSa/s
Single CH 100 MSa/s
Four CH 125 MSa/s
Dual CH 250 MSa/s
Single CH 500 MSa/s
Four CH 250 MSa/s
Dual CH 500 MSa/s
Single CH 1 GSa/s
USB: 40 V (Spitze-Spitze)
(DC + AC Spitze-Spitze)
LAN: 400 V (Spitze-Spitze)
(DC + AC Spitze-Spitze)
400 V (PK-PK)
(DC + AC PK-PK)