Werbung
Verfügbare Sprachen
Verfügbare Sprachen
22.4. Set the network parameters of the oscilloscope
(1)
Connect via USB and enter the menu: Use the supplied USB cable to connect the
oscilloscope with a PC through their USB ports. After connecting successfully, click to show
Function menu, choose "Utility", click "Network".
(2)
Set the network parameters of the oscilloscope: In Network menu, click "OK" to enter
MachineNetSetting. Choose the oscilloscope to be connected from the list. If it's not in the list,
click "Refresh" to refresh the list.
Set IP, the first three bytes should be same as the IP address of the computer in step 1, the
last byte should be different. Here, we set it to 192.168.1.72
The range of the port value is 0 ~ 4000, here we set it to 3000.
The Net mask and Gateway should be set according to the router.
(3) Click "Rework" to restart the oscilloscope.
-107-
Werbung
