PeakTech 1280 Bedienungsanleitung Seite 63

3.3. P 1325 / P 1330
1. Probe Compensation: Measurement signal (3.3V/1KHz) output
2. MULTI Connector for connection to BNC
3. MULTI port: EXT trigger input, trigger output or Pass/Fail output
4. LAN port: Network port which can be used to connect with PC
5. USB port: Supply power by PC USB or the adapter; communicate with PC
6. Signal input of Channel 4
7. Signal input of Channel 3
8. Signal input of Channel 2
9. Signal input of Channel 1
Note: If you use LAN port to communicate with PC, the oscilloscope must be powered by the adapter.
4. How to Connect with PC
1. Install the Software on the supplied CD.
2. Double-click the created desktop shortcut (PeakTech_VO).
3. Connection
Use the supplied USB cable to connect the USB port of the Oscilloscope in
Verweisquelle konnte nicht gefunden werden.
Note: If you use a USB cable which is not supplied by us, some problems such as connection error
and signal disturbing might occur.
4. Install the USB driver:
Open the help document of the software. Follow the steps of title "USB Driver Install Guide" in the
document to install the driver.
to the USB port of a PC.
-63-
Fehler!