PeakTech 1280 Bedienungsanleitung Seite 77

17. Sample and Period window, see
18./19. Channel window of CH2 and CH1, see
20. Display the measured type and value of the corresponding channel, see
Automatically
21. Cursor measure window, see
22/23. The yellow pointer shows the grounding datum point (zero point position) of the CH2
waveform. If the pointer is not displayed, it means that this channel is turned off. (Red pointer
is for CH1).
24. The waveform of CH1
Space: Run/Stop
Enter: Auto set
Q: The voltage division of Channel 1 decreases one
A: The voltage division of Channel 1 increases one
W: The voltage division of Channel 2 decreases one
Instruction of the status information
Auto
Ready
S: The voltage division of Channel 2 increases one level
Trig'd
←: Time base decreases one level
Scan
Stop
→: Time base increases one level
Error
ReSyncing
AutoSet
F1: Open this help document
The statuses of not staying connected with the oscilloscope:
Offline
USBFound
USBDrvErr
MachineNotSupport
The statuses in the process of connecting with the oscilloscope:
Linking
Connect
Match
Syncing
8.3. How to Set the Horizontal System
12. How to Measure with Cursors
Keyboard Shortcuts
level
level
level
Automatic trigger mode
Ready for a tri g ger
Has trigged
Slow scan
Data acquisition stopped
Error occurred
Synchronize with the oscilloscope again
In process of auto setting
No connection with the oscilloscope
Find available USB devices
USB drivers installed error
Can not recognize the device
Being connecting with the oscilloscope
connect successfully
Matching the model
Sync the settings
8.2. How to Set the Vertical System
-77-
10. How to Measure