Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.4. How to Use the Probe Safely
The safety guard ring around the probe body protects your finger against any electric shock, shown as
Figure 0-2 Finger Guard
Warning:
To avoid electric shock, always keep your finger behind the safety guard ring of the probe
during the operation.
To protect you from suffering from the electric shock, do not touch any metal part of the probe
tip when it is connected to the power supply.
Before making any measurements, always connect the probe to the instrument and connect
the ground terminal to the earth.
5. General Care and Cleaning
General Care
To avoid any damage to the instrument or probe, do not expose it to any sprays, liquids, or solvents.
Cleaning
Inspect the instrument and probes as often as operating conditions require. To clean the instrument
exterior, perform the following steps:
Wipe the dust from the instrument and probe surface with a soft cloth.
Disconnect the USB cable before cleaning your Oscilloscope. Clean the instrument with a wet soft
cloth not dripping water. It is recommended to scrub with soft detergent or fresh water. To avoid
damage to the instrument or probe, do not use any corrosive chemical cleaning agent.
Warning:
Before power on again for operation, it is required to confirm that the instrument has already been
dried completely, avoiding any electrical short circuit or bodily injury resulting from the moisture.
-66-
Werbung
