Troubleshooting - Sabo 43-COMPACT E Betriebsanleitung

Pos: 22.2 /Innenteil/Störungsursachen und deren Beseitigung/1 STÖRUNGSURSACHEN UND DEREN BESEITIGUNG @ 0\mod_1115373523343_1521.docx @ 1904 @ 1 @ 1

18 TROUBLESHOOTING

Pos: 22.3.1 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/1 Tabellenkopf @ 0\mod_1115374760156_1521.docx @ 1884 @ @ 1
Fault Possible cause
Pos: 22.3.2 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor springt nicht an E-Start 43-COMPACT (fixed speed) Quantum+675EXi @ 44\mod_1469430359850_1521.docx @ 506084 @ @ 1
Control handle not
Engine does not start
turned down.
up
Fuel tank empty.
Spark plug connector
loose.
Spark plug defective or
soiled or electrodes worn
out.
Too much petrol feed to
engine (spark plug wet).
Air filter soiled.
Battery not charged (only
for electro-start).
Start-up takes longer
than 5 seconds or is
repeated too often
(only for electro-start).
Connection cable
between the ignition key,
battery and engine is
loose or without contact
(only for electro-start).
Pos: 22.3.3 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motorleistung lässt nach @ 33\mod_1408527299785_1521.docx @ 241497 @ @ 1
Air filter soiled.
Engine power
decreasing
Spark plug clogged with
soot.
Fuel old or soiled
Pos: 22.3.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Motor läuft unregelmäßig @ 0\mod_1127909273145_1521.docx @ 1891 @ @ 1
Air filter dirty.
Engine runs irregularly
Spark plug contaminated
with soot.
Pos: 22.3.5 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Starke Erschütterungen (Vibrieren) @ 0\mod_1115377318234_1521.docx @ 1900 @ @ 1
Extreme vibration
Pos: 22.3.6 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Schnitt unsauber, Rasen wird gelb, Benzin @ 0\mod_1115377468656_1521.docx @ 1898 @ @ 1
Blade blunt.
Unclean cut, lawn is
yellow
Cutting height too low.
Engine speed too low.
Mowing too fast.
Insufficient overlapping
of cuts when mowing.
Lawn becomes matted.
Pos: 22.3.7 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Auswurf verstopft, Benzin, TurboSignal MUSTER @ 17\mod_1331728502002_1521.docx @ 134644 @ @ 1
Ejector blocked
Remedy
Press the control handle onto
the upper part of the bar D .
Fill up with clean and fresh
fuel.
Push plug connector in place
or have it checked by an
Pos: 22.3.8 /Innenteil/Störungsursachen und deren Beseitigung/Störungstabellenelemente/Gemulchte Gras sieht schlecht aus Heckauswurf @ 5\mod_1183467132357_1521.docx @ 35950 @ @ 1
authorised workshop.
Mulched grass
appearance is poor:
Replace or clean spark plug,
clumps, excessive
set electrode distance Y .
clippings, rough cut.
0.5 mm
(for model SA1462, SA1461,
SA1406)
0.7 - 0.8 mm
(for model SA1741).
Have it checked by an
authorised workshop.
Clean or replace the air filter
insert W .
Charge battery W1 , X1 .
If you experience start
difficulties, contrary to
expectations, the battery
must also be charged in
between.
Pos: 22.4 /Innenteil/Störungsursachen und deren Beseitigung/Störungsursachen und deren Beseitigung Text Benzin @ 0\mod_1115378183390_1521.docx @ 1905 @ @ 1
In case of faults and defects which have not been listed here, please contact the
Connect the battery
nearest authorized dealer.
connector with the mating
Repairs which require specialized knowledge should only be performed by a qualified
connector on the harness U1
expert. Your authorized dealer will naturally also be glad to help if you do not wish to
or check it or have it checked
perform the maintenance work described here yourself.
by an authorised workshop.
Pos: 23.1 /---------- 1 Leerzeile ---------- @ 0\mod_1114611787140_1521.docx @ 2070 @ @ 1
Clean or replace the air filter
insert W .
Have it checked by an
authorised workshop.
Empty the petrol tank and fill
with fresh petrol.
Clean or replace air filter
insert W .
Have it cleaned by an
authorized dealer.
Have it checked by an
authorized dealer.
Have it checked by an
authorized dealer
Have it sharpened and
balanced by an authorized
dealer Q .
Adjust to higher cutting height
I .
Operate at max. rpm.
Adjust mowing speed.
Tall grass conditions may
dictate that more overlapping
of cuts is required.
A lawn scarifier can remedy
the problem considerably
13
TurboSignal ignored Empty the collecting bag L .
J + K .
Engine speed too low. Have it checked by an
authorized dealer
Cutting height too low Set higher cutting height I .
with grass too high.
Mowing speed too fast. Adapt mowing speed, switch
motor drive off if necessary.
Grass is damp. Allow the lawn to dry.
Blade blunt. Have it sharpened and
balanced by an authorized
dealer.
Mulching rule not Adjust to higher cutting height
followed (cut max. 1/3 of I .
the grass height; the
Convert mower to rear
height of the grass to be
discharge U2 + S1 and
cut must be lower than
mow grass first with higher
10 cm)
cutting setting.
Travel speed too fast. Adjust travel speed.
Grass build-up under Adjust to higher cutting height
deck. I .
Insufficient overlapping Tall grass conditions may
of cuts when mowing. dictate that more overlapping
of cuts is required
Grass not dry. Adjust to higher cutting height
I .
Let grass dry.