Setting And Activating/Deactivating Lower Temperature Alarm; Displaying/Resetting Maximum Value Storage For Indoor Temperature; Displaying/Resetting Minimum Value Storage For Indoor Temperature - Conrad 672861 Bedienungsanleitung

 Setting and Activating/Deactivating Lower Temperature Alarm
• Touch the display area „IN TEMP" repeatedly until the indoor temperature and the display „LO AL" flashes.
• Select the lower threshold of the indoor temperature with the buttons „+" and „-". Keep the respective button pressed
for quick adjustment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
undercut, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„LO AL" and the icon „

To get to the next subfunction (displaying/resetting the maximum value storage for indoor temperature) ->
touch the display area „IN TEMP" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
 Displaying/Resetting Maximum Value Storage for Indoor Temperature
• Touch the display area „IN TEMP" repeatedly until the indoor temperature maximum and the display „MAX" (to the
left of the weather symbols) flash.
• To reset the maximum value storage, keep the display area „IN TEMP" pushed for 3 seconds. The new maximum is
the currently measured indoor temperature until it changes.

To get to the next subfunction (displaying/resetting the minimum value storage for indoor temperature) ->
touch the display area „IN TEMP" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
 Displaying/Resetting Minimum Value Storage for Indoor Temperature
• Touch the display area „IN TEMP" repeatedly until the indoor temperature minimum and the display „MIN" (to the left
of the weather symbols) flash.
• To reset the minimum value storage, keep the display area „IN TEMP" pushed for 3 seconds. The new minimum is
the currently measured indoor temperature until it changes.

To get back to the first subfunction (select the temperature unit) -> touch the display area „IN TEMP" briefly
2x
Leaving setting mode -> touch the button „IN TEMP" briefly 1x (or touch another display area wait for 30
seconds without touching the touch screen)
80
" appears above the display „LO AL". When the threshold value set is
" continue to flash, however, until the measured value rises above the threshold value set.