Assembly Of The Outdoor Sensors - Conrad 672861 Bedienungsanleitung

8. Assembly of the Outdoor Sensors

The temperature/humidity sensor and the wind and rain sensor and the solar module all can be installed on the
included mast holder.
All components are wired to the temperature/humidity sensor, the transmitter for radio transmission of all measured
data is integrated in the temperature/humidity sensor.
This means that not only can all sensors be very easily installed at one location of your premises, but a total of
2 rechargeable batteries type AA/mignon are sufficient for all sensors. signing on of the sensors to the weather station
is much easily than in other weather stations because of this.
Proceed as follows to assemble and mount the outdoor sensors:
• First remove all components of the outdoor sensors from the packaging.
• Plug the wind speed sensor into one of the two sockets on the plastic Y holder and fasten it with a long screw (A) and
a nut (D).
Observe that the tab at the wind speed sensor is guided precisely into the Y-holder slot (see arrow in the right figure),
since the screw can otherwise not be pushed through.
D
• Then the wind direction sensor must be plugged into the second
socket of the plastic Y-holder; again, observe that the tab at the
wind direction sensor is guided precisely into the Y-holder's slot.
Fasten the wind direction sensor to the Y-holder with a long screw
(A) and a nut (D).
• The wind speed sensor has a short, thin cable with a Western plug.
Connect the Western plug to the corresponding socket at the bottom
of the wind direction sensor so that it latches.
The cable can be attached to the cable brackets at the bottom of
the Y-holder.
A
A
B C
D
A D
59