Conrad 672861 Bedienungsanleitung Seite 61

• Plug the solar module into the upper end of the weather protection housing for
the temperature/humidity sensor.
Observe that the tab at the solar module is guided precisely into the weather
protection casing, since the screw can otherwise not be pushed through.
• Fasten the two parts with a long screw (A) and a nut (D).
• Install the second L-holder precisely opposite from the metal pipe.
• Insert the temperature/humidity sensor into the square plug-on socket and screw
it on with the short screw (B) and a nut (D).
The sensor's battery compartment can point either inward or outward.
• The weather protection housing that is pushed onto the top of the temperature/
humidity sensor will later service to protect it from precipitation and direct solar
irradiation to avoid measuring errors.
• Connect the cable from the solar module to the „RAIN" socket at the temperature/
humidity sensor.
• Carefully push the weather protection housing onto the temperature/humidity
sensor.
• Connect the cable of the rain sensor to the „RAIN" socket at the bottom of the
solar module.
• Last, connect the cable of the wind direction sensor to the „WIND" socket at the
temperature/humidity sensor.
• Wiring is now complete. Excess wire is fastened to the plastic holders or the
metal rod with cable ties.
D
A
B
D
D
B
61