Soldering - Parkside PLBS 30 A1 Bedienungs- Und Sicherheitshinweise

Operation

Soldering

If inhaled, vapours may cause headaches and fatigue as
well as other symptoms.
— The soldering pencil has a rated output of 30 watts and is therefore
ideal for electronics soldering.
— The design of the soldering pencil makes it especially suitable for
use where access is difficult or for fine soldering work.
— To achieve the best results use electronics solder 1.0 or 1.5 mm
diameter 60 % Sn, 40 % Pb. We recommend the use of soldering
paste (not soldering grease or soldering fluid) as a flux.
C lean the soldering tip
A fter cleaning the tip
This is done by melting solder on to the hot soldering tip
G uide the soldering tip
P lace the solder (with flux) between the joint site and the tip
to melt it.
C ontinue to feed further solder until the whole joint has a covering
of solder.
T hen quickly remove the soldering tip in order to avoid overheating
the molten solder.
A llow the solder to harden while not subjecting it to vibration or
movement.
N ote: The flux is either already contained in the solder or applied
separately. Ask the advice of the retailer when buying solder in or-
der to choose the most suitable solder for your intended purpose.
Attachments and applications:
ATTENTION! Do not carry out any special changes or repairs to the
electrics or other parts. Exceptions are permitted if the person carrying
14 GB/IE
on the moist solder sponge
2
it must be "tinned" (coated with solder).
2
to the intended joint site and heat the joint.
2
.
8
.
2
2