Preparing For First Use; Insert / Replace The Soldering Tip - Parkside PLSD 48 B2 Gebrauchsanleitung

•CAUTION! RISK OF POISONING! Do not breathe fumes.
•In the case of working for prolonged periods, in which
hazardous fumes may arise, always ensure adequate
ventilation of the workplace. It is recommended to wear
protective clothing such as protective gloves, mouth protection
and a working apron.
•Avoid eating, drinking and smoking in rooms where soldering
is taking place. Otherwise, traces of lead adhering to
the hands could get into the human organism through food or
cigarettes.
•Remove inflammable objects, liquids and gases from the
working area of the device before use. Keep your work area
clean to prevent accidents.
•Always thoroughly wash your hands after soldering.
•Never throw soldering waste into household waste. Soldering
waste is hazardous waste. National and international safety,
health and work safety regulations must be observed.
•After use, put the device in the holder (2) and allow it to cool
off before packing it away.
•When the device is not being used, keep it in a safe place
and protected from dust and moisture.

Preparing for first use

Inserting / replacing the soldering tip
BEWARE! RISK OF BURNS!
Never heat the soldering iron (3) without fitting a soldering tip (4) .
•The soldering tip (4) is only to be removed after the device has been switched
off and it has cooled down.
•The soldering tip (4) has a screw thread and can therefore be replaced
quickly and easily in the soldering iron (3).
•To remove, turn the soldering tip (4) anti-clockwise.
•To secure, turn the soldering tip (4) clockwise.
NOTE
•Before use, remove the protective cap from the soldering tip (4).
•Before using the digital soldering station for the first time and also when using
a new soldering tip (4), the soldering tip (4) must be tinned first.
| GB
16 PLSD 48 B2