Before Use; Changing The Soldering Tip; Inserting The Battery; Use - Parkside PLSA 20-Li A1 Originalbetriebsanleitung

Before use

Changing the soldering tip

CAUTION! RISK OF BURNS!
► Never heat the soldering iron 1 without a
soldering tip q.
■ Removing the soldering tip q may only be
carried out when the appliance is switched off
and the soldering tip q has cooled down.
Loosen the retaining nut 9 completely and
♦
remove it.
♦ Pull the fixing sleeve 0 off the soldering
iron 1.
Change the soldering tip q.
♦
♦ Proceed in the reverse order to reassemble
the soldering iron 1.

Inserting the battery

♦ Push the charged battery 5 into the soldering
station.
It clicks into place audibly.
│ GB │ IE
■ 4

Use

Switching on/off
Switching on
Press the ON/OFF switch 6.
♦
The status LED 7 flashes red
rapidly. The soldering iron 1
heats up.
♦ As soon as the status LED 7 lights
up green, the soldering iron 1 is
ready for use.
NOTE
► After 10 minutes, the appliance switches off
automatically and reverts to cooling mode.
Press the ON/OFF switch 6 again to reheat
the appliance.
► Before using the soldering station for the first
time and before using a new soldering tip, the
soldering tip q must first be tinned.
Switching off
NOTE
► After use, always put the soldering iron 1
back into the holder for the soldering iron 3.
♦ Press the ON/OFF switch 6
again. The status LED 7 flashes
red slowly for around 10 minutes.
This is the cool-down mode and is intended to
warn the user that the soldering iron 1 is still
dangerously hot.
NOTE
► After the status LED 7 has gone out, leave
the soldering iron 1 in the holder for the
soldering iron 3 for at least 30 minutes to
cool down.
♦ When the appliance is not in use, remove the
battery 5. To do so, press and hold down the
release button 8.
PLSA 20-Li A1