Installation; Connecting Target Computers; Connection To The Central Module - Guntermann & Drunck DVICenter DP32 Installationsanleitung

DVI-CPU « Target modules

Installation

Connecting target computers

Keyb. Mouse
NOTE:
Both keyboard and mouse signals can be transmitted to the computer using
the PS/2 or the USB ports.
Keyb.: Use the purple plug of a Twin-PS/2 cable to connect the purple PS/2 socket
(keyboard) to this port.
Use the green plug of a Twin-PS/2 cable to connect the green PS/2 socket
Mouse:
(mouse) of the computer to this port.
Use the USB device cable to connect one of the computer's USB ports to this
USB K/M:
port.
DVI-D CPU: Use the video cable to connect the digital video output of the computer to
this port.
Trans. Line In Line Out Power Loop Power In
Service
Use an audio cable to connect the Line-Out interface of the computer to this port.
Line In:
Use an audio cable to connect the Line-In interface of the computer to this port.
Line Out:

Connection to the central module

Transmission: Use a category 5e (or better) twisted pair cable to connect the Transmis-
sion ports of the individual target modules to a Dynamic Port, which has been config-
ured for connecting a target module.
NOTE: For more information, you can also refer to the instructions in the para-
graph Connecting target modules to the central module on page 7.
ADVICE: If the network fails or a port at the central module is not working, you can
establish a direct connection between a target and a user module.
Use a category 5e (or better) crossover cable to connect the modules.
31 · G&D DVICenter DP32
USB K/M DVI-D CPU