Installation; Power Supply - Guntermann & Drunck DVICenter DP32 Installationsanleitung

Installation

The following pages describe the configuration of the Dynamic Ports (optional) and
the installation of the devices of the KVM system.
NOTE: When choosing a place for the device, please ensure to comply with the
ambient temperature limit (see Technical data on page 25) close to the device. The
ambient temperature limit must not be influenced by other devices.
When installing the devices, make sure to only place a maximum of three devices
directly on top of each other. This provides sufficient circulation of air and mutual
thermal interference can be avoided. After having installed three devices, provide
for a distance of at least 3cm.

Power supply

Dynamic Ports
16 18 20 22
15 19
17 21
Plug one of the supplied power cable in this interface. Connect the
Main Power:
power cable with a power outlet and turn the power button on.
If required, plug one of the supplied power cable in this interface to
Red. Power:
establish a redundant power supply. Connect the power cable with a power outlet of
another power circuit and turn the power button on.
CPU side
24 26
28 30
23 25
27 29
Central Module » Installation
Main Power
32
Ident. Power
Red.
Main
31
G&D DVICenter DP32 · 4
Red. Power