Status Displays; Front Panel - Guntermann & Drunck DVICenter DP32 Installationsanleitung

DVI-CON « User modules

Status displays

Front panel

The LEDs on the front panel of the user module inform you about the system's
operating status.
Section LED
Power Red.
Main
Status Trans.
System on
Console Video
K/M
45 · G&D DVICenter DP32
Status Meaning
on The optional power pack is connected and the required voltage
(12 Volt) is available.
off The optional power pack is not (properly) connected.
on The main power supply provides the required voltage.
off The power button is turned off or the connection with the mains
could not be established.
Check the proper connection of the power supply cable.
on The communication with the matrix switch could be established.
off The communication with the matrix switch could not be estab-
lished.
The device is booting or carries out a firmware update.
blink- The system is ready for operation.
ing
on Stable image signal at video input.
off The incoming video signal could not be detected or it lacks the
required quality to be processed by the system.
on A local keyboard was found.
off No power at PS/2 interface or USB bus.
blink- The CPU input (PS/2 or USB) is active and ready.
ing No local keyboard was found.
Power Status
Red. Trans.
Main System
Console Service
Video
K/M