Power Supply - Guntermann & Drunck DVICenter DP32 Installationsanleitung

Power supply

Power In: Plug the power cable of the power pack in this interface. Then connect the
power cable to the power pack and a power outlet.
NOTE: If a power pack connected to the Power In interface provides power to a tar-
get module, up to two other target modules can use this power source via Power
Loop cables.
1. Connect the power pack  to the first target module.
2. Plug a »Power Loop« cable  in the Power Loop interface of the first target mod-
ule. Connect the other end to the Power In interface of the second target module.
3. If required, connect another »Power Loop« cable  to the Power Loop interface of
the second target module. Connect the other end to the Power In interface of the
third target module.
Trans. Service Line In Line Out
Trans. Service Line In Line Out Power

Power Loop Power In
Target modules
Trans. Service Line In Line Out

Loop Power In
G&D DVICenter DP32 · 32
» DVI-CPU
Power Loop Pow er In
