Installing And Connecting Target Modules; Connecting Target Computers To Target Modules; Connecting Target Modules To The Central Module - Guntermann & Drunck DVICenter DP32 Installationsanleitung

Installation « Central Module

Installing and connecting target modules

IMPORTANT:
You can place target modules up to 140 metres away from the central
module.

Connecting target computers to target modules

 Connect the target computer to the different target modules.
This step is described in the paragraph Target module on page 31.

Connecting target modules to the central module

 Connect the Transmission interfaces of the target modules to the Dynamic Port that is
configured for connecting a target module. In the default, these are ports 9 to 32.
Use a category 5e (or better) twisted-pair cabling for connecting the devices.
NOTE: If required, enable the signalling in the Dynamic Ports modes (see page 17).
The Dynamic Ports for connecting the target modules are highlighted by green
LEDs.
Console side
us In
6
2 4
s Out
1 3 5
IMPORTANT: The DVI-CPU-UC target module provides two Trans. interfaces. Only
connect one Trans. interface of the target module (see page 37) to the matrix switch.
7 · G&D DVICenter DP32
8 10 12 14
9 13
7 11
Dynamic Ports
16 18 20 22
15 19
17 21
CPU side
24 26
28 30
23 25 27 29
32
Ident.
31